Songs not updating on sandisk fuze
In order to continue, you first need to restore the original San Disk firmware to your Sansa.San Disk's original Sansa Fuze may have had a solid run -- it's been a particular favorite among those looking for a good, inexpensive player that doesn't skimp on features or audio quality -- but there's no question that it was long overdue for an update, and San Disk recently came through on that front with the completely revised Sansa Fuze . While unquestionably an improvement over the original Sansa Fuze in the design department, the Fuze still feels like it's a few steps behind much of the competition.It is also possible that you have a v2 version of the player.See the here for a description of how to tell if it is.However, not following the instructions during install can force you to undergo a lengthy recovery process. Please free memory." and skips the database refresh. There are two ways to do this: Right now Rockbox does not communicate over the serial/dock or remote port.Because of this, any accessory, such as a remote or stereo mount, that can actually control playback on the Sansa will not work.
If the firmware version of your c200 is not in the list, it may still work but just hasn't been verified yet.This has been investigated here but the exact cause is still unknown.For some reason the FM Radio disappears from certain e200's main menus. If you cannot boot into the original firmware by holding at startup or otherwise cannot get a response from your player, see Sansa E200Unbrick. If the bootloader does not load Rockbox properly have a look at the return code.Boasting a considerably sleeker design, the Fuze replaces the Fuze's venerable tactile click wheel with a capacitive touch panel (but not a touchscreen), and it hangs onto many of the features that made the original Fuze stand out, including a micro SD card slot, FM radio, and support for a wide range of formats (including FLAC and AAC). Although not unreasonably large by any means, it is a bit bulky for such a basic player, and the all-plastic body doesn't exactly inspire much confidence in its durability the first time you pick it up -- it does seem sturdy enough to hold up to reasonable wear and tear, though.As we mentioned, the biggest change is the inclusion of a capacitive touch panel instead of a tactile click wheel, which leaves the power button and volume rocker switch as the only physical buttons on the player.
People work on it when they have the time and inclination to do so. This FAQ applies only to models using Portal Player SOCs (currently e200 v1 and c200 v1). Immediately after doing this, hold down the | and all of its sub-directories read-only.